Casella CEL-352 dBadge Manual de instrucciones descargar pdf (Pagina 25)

Casella CEL-35X dBadge Users Handbook – Page 25

6 MOUNTING THE CEL-35X

The recommended location for mounting a noise exposure meter

varies depending upon the legislation specific to a country. Most

countries recommend a position close to the ear (10-15cm) so the

dBadge can be mounted on a collar or shoulder. The UK

legislation recommends mounting on the top of the shoulder to

avoid reflections from the head and body affecting the

measurements as much as possible. All mounting clips are

attached to the CEL-35X dBadge by two screws. By removing the

screws with the screwdriver provided, the mounting clips can be

changed. As shown in Figure 24, please reinsert the screws into

the correct hole, otherwise damage could be caused to the

dBadge.

6.1 CEL-6351 Pin Mounting Clips

These clips can be mounted to a variety of clothing. Caution

should be used when fitting these to an employee to avoid piercing

the skin. These clips should not be used on fire retardant clothing

as piercing the outer layer will compromise the employees’

protection.

6.2 CEL-6352 Crocodile Clip Mounting Kit

The CEL-6352 crocodile mounting clips are fitted to the CEL-35X

dBadge upon delivery as they can be fitted to virtually any clothing

type. The CEL-6352 is used for attaching the CEL-35X to clothing

and should be used where piercing the employees’ clothing is not

desired.

Illustrations of the CEL-6351 and CEL-6352 mounting clips are

shown in Figure 24.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 40 41

Sin comentarios

Casella CEL-352 dBadge Manual de instrucciones Pagina 25